Error Codes - Igo Elite User Manual

SET 3: Setting the Tire-Size
Having the correct tire-size set into the system is very important. It will ensure
that the data being displayed on the screen is accurate.
On the side of every tire you can find the tire-size.
Default Tire-Size of your ebike:
28 inch - 40-622 - Circumference: 2205 mm
SET 4: Choosing KM/H or MPH
Depending on your location, you will want to have the information on the
screen displayed in the proper unit.
Pressing the 'PLUS' or 'MINUS' buttons while in this mode will allow you to
switch between having the information displayed in kilometers or miles.

Error Codes

It is possible for a system error to occur.
When this happens, the display will show an error-code which will allow you
or your dealer to easilly and properly diagnose an error in the electrical
system of your ebike.
Error 1: Problem with the 3-phase control from the electronic controller
Error 2: Problem with the throttle connection
Error 3: Motor 3-phase wire is loose or defective
Error 4: Motor Hall Sensor signal malfunction (malfunction in motor or cable)
Error 5: Malfunction in brake sensor (signal)
Error 6: Battery voltage is too low
Error 7: Motor is stalled
Error 8: Malfunction in the electronic controller (signal)
Error 9: Malfunction in the display (signal)
9