Advertisement
PREPARING THE
5
ULTRA-TRAK FOR USE
5.0 - PRIME THE ULTA-TRAK
A
Position the Ultra-Trak where you are going to begin application.
B
Use the lift handle to lower the head assembly down to the floor,
C
Set the "Power On" switch to "On."
D
Press the "Manual Pump" switch and hold until solution flows through the
distribution tube onto the floor.
5.1 - SATURATE THE APPLICATION PAD
A
Ensure you have enough solution on the pad to prevent streaking.
B
While lifting and lowering the head assembly, move the Ultra-Trak back and
forth to saturate the pad with solution.
ENSURE THERE IS ENOUGH
SOLUTION ON THE PAD. IF
THE PAD IS NOT SATURATED,
STREAKING CAN OCCUR.
Advertisement
