Installation - Honeywell 2000 Series Product Data

1(25) 2-5/16
(59)
Fig. 9. C7031J, C7041J dimensions in in. (mm).

INSTALLATION

When Installing this Product...
1. Read these instructions carefully. Failure to follow them
could damage the product or cause a hazardous
condition.
C7031B,D,G,J C7041B,C,D,F,J,K,P,R SERIES 2000 ELECTRONIC TEMPERATURE SENSORS
2-5/16 1-1/2
(59) (38)
2-5/16
(59)
4
4-3/16
(70)
(107)
1 MAXIMUM PIPE DIAMETER SHOWN.
MINIMUM PIPE DIAMETER: 1-5/8 (41)
Fig. 8. C7041K dimensions in in. (mm).
1-11/16
(43)
1-11/16
(43)
4-3/16 4
(107) (70)
4 THERMISTORS PLACED
ON A 12 FOOT (3.7M) WIRE.
M22133
4-3/16 (107)
1-1/2
(38)
9/16 (14)
7-1/8 (182)
5 (127)
1
1-11/16
1-1/4
(43) (32)
FOAM PAD
2. Check the ratings given in the instructions and on the
product to make sure the product is suitable for your
application.
3. Installer must be a trained, experienced service
technician.
4. After installation is complete, check out product
operation as provided in these instructions.
CAUTION
Electrical Shock or Equipment Damage Hazard.
Can shock individuals or short equipment
circuitry.
Disconnect power supply before installation.
Mounting
The method of mounting depends on the particular application
of the C7041 Temperature Sensor. The following procedures
include outdoor, duct, immersion well and strap-on
applications. Also refer to the instructions for the electronic
control.
Outdoor Mounting (C7031G, C7041F)
The C7031G and C7041F sense outdoor air temperature.
Mount this control where it can sense average outdoor air
temperature. Normally, the north side of a building provides a
suitable location.
NOTE: C7031G and C7041F are weatherproof for outdoor
use. Knockouts allow for 1/2 in. conduit connection.
1. Remove and set aside the wiring box cover.
2. Mount the sensor to standard 1/2 in. conduit.
NOTE: Mount sensor so that the element points down.
3. Make wiring connections using two wire nuts.
4. Reattach the wiring box cover.
5
COPPER PLATE
M22134
63-2590—3