Operation - NCT MSL-200 Maintenance Manual

3. Make sure to provide appropriate lighting equipment in the working area, to facilitate
safety and inspection.
4. Cutting tools and other objects to be positioned at the periphery of machine should be
positioned at their appropriate locations, to keep the walking path clean and clear.
5. Selection of cutting tools shall be made in consideration of whether they comply with the
maximum limits pre-set in the item of cutting tools in the specification of this machine
(which shall be used for reference) and if they will interfere with the work piece and op-
tional accessories (fourth axis, etc.). Safety distances shall be considered when deciding
the distances of cutter reserve, cutter feed, and cutter replacement. To set cutting tool
specification, please refer to 2.8.
CAUTION!
1. After a cutting tool is installed, test lathing is required to make sure there is no problem
with the tool.
2. Make sure the dimension of work piece conforms to machine specification, to avoid inter-
ference or collision in its range of travel.

1.4.5 Operation

WARNING!
1. Do not wear gloves when operating the machine or it may result in accident or danger.
2. The operator should not allow their hair hang to loosely, or it may result in accident or
danger.
3. Bailey ropes, steel cables, hoists or lifting machines shall have sufficient strength to carry
the load.
4. Only the operator who has received professional training may operate the forklift, crane,
hoist and other similar equipment.
5. Pay special attention when operating the forklift, crane or similar equipment. In operation,
make sure to prevent collision and damage to the machine and its surrounding environ-
ment.
6. To move a larger work piece, two or more persons shall be needed to move it together, to
avoid danger.
7. In machining operation, the work piece must be securely and properly clamped.
8. Make sure the machine has stopped properly before trying to adjust the area from cutting
liquid spray nozzle to cutter point.
9. Do not hand touch rotating work piece or spindle, or other rotating machine parts.
10. Do not remove the safety protective cover of machine without permission.
11. Do not use hands to remove iron scraps on cutting tool. Make sure to use a brush for that
purpose, to avoid cutting injury.
12. Make sure the machine has stopped properly before trying to remove the cutting tool.
13. When working in a dusty environment, the operator should wear protective gear. When
the machine is machining graphite work piece or a work piece with powdered dusts,
the operator must wear a protective mask or turn on the dust collector, because working in
a dusty environment can result in occupational injury to personnel.
CAUTION!
1. In machining process, do not open the protective doors of all machine parts.
2. In heavy machining process, make sure to prevent excessive accumulation of iron scraps,
which may cause rising temperature and result in a fire inside the machine.
NCT Ipari Elektronikai Kft.
H-1148 Budapest, Fogarasi út 7.
Phone: +36 1 467 6300
www.nct.hu
MAINTENANCE MANUAL
8 / 32
MSL-200
CNC LATHE
10 September 2018