Table of Contents
Advertisement
conspicuous places, to prevent other people from turning on the switches and causing
accidental harm.
2. Turning on machine power supply, and any maintenance or servicing is dangerous.
As a general rule, make sure to turn off the non-fuse switch of the main circuit before at-
tempting maintenance.
WARNING!
1. Maintenance of electrical devices should be executed by professionals only. Do not main-
tain the machine yourself, you should contact concerned personnel. Do not service
the machine without permission, so as to avoid danger.
2. Absolutely prohibit moving or modifying over-travel limits and linking mechanism,
including mechanism-related parts.
3. When working at an elevated place, do not stand on top of the machine or plate work.
Make sure to use pedal steps or a ladder to ensure safety.
Use only electrical parts, fuses, cables and wires that are made by qualified manufacturers.
1.4.10 Subsequent jobs after maintenance
WARNING!
1. After maintenance, disassembling tools, removed and replaced parts, all types of fasteners
and instruments should be collected, assorted and returned to their original positions.
2. After maintenance, make sure to clean the working environment and keep the ground
surface clean and tidy, to provide a comfortable and safe working environment.
3. After maintenance, the operator should keep the replaced parts and waste oil products
away from the machine and at appropriate locations in the factory to ensure safety.
CAUTION!
1. Maintenance personnel should check if machine operation is safe.
2. Maintenance and inspection data should be filed in records for future reference.
3. In case maintenance personnel cannot proceed in case of irregularity found during
maintenance and inspection, immediately contact our factory or dealer to conduct mainte-
nance and inspection. Do not try to disassemble the machine for maintenance when they
do not understand the circumstances.
1.5
Potential hazard zones of the machine
The user should clearly know that all rotating or moving mechanisms, especially moving
at a high speed, in incorrect operation or through careless behaviour (such as unintentionally
or unknowingly touching of a knob or key, etc.) may result in unwanted activation of the ma-
chine and possible danger. Therefore, when the machine was designed, all moving or rotating
mechanisms were installed inside safety protective hoods to avoid direct contact with person-
nel. However, they could not avoid unexpected dangerous behaviour by the operator. There-
fore, in addition to correct operational knowledge, the operator and maintenance personnel
should gain correct understanding of potential hazardous zones of this machine, and be alert
for possible danger, to avoid unnecessary accident and injury.
The arrow signs
movement and rotating mechanism. The operator and maintenance personnel should ensure
their operation is within the range of movement.
NCT Ipari Elektronikai Kft.
H-1148 Budapest, Fogarasi út 7.
Phone: +36 1 467 6300
www.nct.hu
and circular signs
10 / 32
MAINTENANCE MANUAL
in the following diagram indicate high-speed
MSL-200
CNC LATHE
10 September 2018
Advertisement
Table of Contents
