Sony 3-295-946-12(1) Operating Instructions Manual page 25

Performing Auto Calibration
TV INPUT TV ?/1
AV ?/1
SLEEP DMPORT
SYSTEM STANDBY
VIDEO1 VIDEO2
SAT TV SA-CD/CD TUNER
2CH A.F.D. MOVIE
1 2
4 5
7 8
>10 MEMORY
-
0/10 ENTER
CLEAR
TOOLS/
OPTIONS
DISPLAY
O
MENU/HOME
RETURN/EXIT
TV CH
Press AMP MENU, then press
AUTO CAL.
You can also select "A.CAL YES" in the
A. CAL menu.
The following appears on the display.
A.CAL [5] t A.CAL [4] t A.CAL [3] t
A.CAL [2] t A.CAL [1]
The measurement process will take
approximately 30 seconds to complete.
The table below shows the display when
measurement starts.
Measurement for
Speaker existance
Speaker gain, distance,
frequency response
Subwoofer gain and distance
Note
You cannot measure the speaker height of the
surround speakers. Set this value using "SUR POS."
parameters in the SYSTEM menu (page 35).
?/1
?/1
switch
BD DVD
Input
buttons
MUSIC
THEATRE
3
DVD/BD
MENU
AUTO CAL
6
AUTO CAL
D.TUNING
9
D.SKIP
AMP MENU
AMP MENU
MUTING
MUTING
TV VOL
MASTER VOL
MASTER
VOL +/–
TV CH
Display
TONE
T.S.P.
WOOFER
Tip
When Auto Calibration starts:
– Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
– Avoid making noise to get a more accurate
measurement.
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you do the following during the
measurement process:
– Press ?/1 or MUTING.
– Press input buttons on the remote or INPUT
SELECTOR on the receiver.
– Change the volume level.
– Press AUTO CAL again.
Confirming/saving the
measurement results
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
Measurement Display
result
When the SAVE
measurement
process
completes
properly
When the ERROR
measurement XXXX
process fails
Explanation
Proceed to step
2.
See "When
error codes
appear" (page
26).
continued
25 GB