Launch X-431 PAD III Manual page 98

LAUNCH
*Note: The sequences of inside the vehicle and outside the vehicle test are almost the
same, but under inside the vehicle condition, all loads in vehicles must be powered off
for getting an exact test value.
1. Firstly, the system detects whether floating electricity exists or not before
testing. If yes, turn on the headlamp to remove it. Otherwise, the system
starts test program directly.
2. Tap [Inside the vehicle], the system starts detecting floating electricity
automatically. If floating electricity is detected, it will prompt you to turn on the
headlamp.
3. Follow the on-screen instructions to turn on headlamp, the system starts
removing floating electricity.
4. Once the floating electricity is removed, a prompt message box "The floating
electricity has been removed, please turn off the headlamp to continue the
testing" will appear on the screen.
5. Follow the on-screen instructions to turn off the headlamp and tap [OK], the
system will continue the testing. Tap
selection screen.
6. Select a testing standard except for JIS and tap
11-6 will appear. Users can adjust capacity size by tapping on < or > or by
dragging the slider on the bar.
, it will enter testing standard
Fig. 11-5
89
X-431 PAD III User Manual
, a screen similar to Fig.