Vehicle Connection (For Commercial Vehicle/ Gasoline & Diesel Version) - Launch X-431 PAD III Manual

LAUNCH
B. Battery Clamps Cable: Connect one end of the battery clamps cable to
vehicle's battery, and the other end to the power jack of OBD I adaptor.
4.3.3 Vehicle connection (For Commercial Vehicle/ Gasoline & Diesel
Version)
The method used to connect the VCI module to a vehicle's DLC depends on the
vehicle's configuration as follows:
A. OBD II Vehicle Connection: Plug one end of the diagnostic cable into the
vehicle's DLC, and the other end into the diagnostic socket of the VCI module,
and then tighten the captive screws.
B. Non-OBD II Vehicle Connection: For vehicles with non-OBD II diagnostic
socket, a non-16pin connector (adaptor cable) is required.
Fig. 4-13
Fig. 4-14
Fig. 4-12
Fig. 4-13
26
X-431 PAD III User Manual