Adjustment; How To Enter Service Factory Mode; Possible Cases Where Readjustment Is Required - Pioneer PDP-R05U Service Manual

1

6. ADJUSTMENT

QQ
3 7 63 1515 0
1. At shipment, the unit is adjusted to its best conditions. Normally, it is not necessary to readjust even if an assembly is replaced. If the
adjustment is shifted or if it becomes necessary to readjust because of part replacement, etc., perform the adjustment as described below.
A
2. Any value changed in Service/Factory mode will be stored in memory as soon as it is changed. Before readjustment, take note of the
original values for reference in case you need to restore the original settings.
3. Use a stable AC power supply.

6.1 HOW TO ENTER SERVICE FACTORY MODE

Refer to the technical document (Service Know-How).
B

6.2 POSSIBLE CASES WHERE READJUSTMENT IS REQUIRED

When any of the following assemblies is replaced
POWER SUPPLY Unit
AV BOARD Assy
MR MAIN BOARD Assy
C
TUNER Board Assy
TE
L 13942296513
Other assemblies
When any part in the following assemblies is replaced
POWER SUPPLY Unit
D
AV BOARD Assy
MR MAIN BOARD Assy
TUNER Board Assy
E
Other assemblies
Adjustment items
1 Audio Level Adjustment
www
2 Video Level Adjustment
3 Audio Level Adjustment
4 MSP Adjustment
F
5 MSP Adjustment
148
1
http://www.xiaoyu163.com
2
NOTE :
x ao
y
. i
PDP-R05U
2
http://www.xiaoyu163.com
3
8
No adjustment required
No adjustment required
No adjustment required
No adjustment required
However, HOST ID is changed. Please tell a customer about new HOST ID.
Refer to the following note and instruction manual.
Q Q
3 6 7 1 3
No adjustment required
The assembly must be replaced as a unit, and no part
replacement is allowed.
If the front end (U7501, U7502) is replaced, adjustment
is required.
The assembly must be replaced as a unit, and no part
replacement is allowed.
The assembly must be replaced as a unit, and no part
replacement is allowed.
No adjustment required
Checking the Cable Card ID
The Media Receiver has a slot for a cable card that is used for
managing your information by the cable TV company. The
following procedure allows you to check your Cable Card ID and
the Host ID.
1
Press HOME MENU.
2
Select "Tuner Setup". (
u163
3
Select "Channel Setup". (
4
Select "POD ID". ( / )
.
• The Host ID and Cable Card ID appear.
5
Press HOME MENU to exit the menu.
3
4
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
m
/ then ENTER)
co
/ then ENTER)
4
9 9
2 8 9 9