List Of Rs-232C Commands - Pioneer PDP-R05U Service Manual

1

6.8 LIST OF RS-232C COMMANDS

QQ
3 7 63 1515 0
RS-232C commands can be used in Service Factory mode.
Before using RS-232C commands, it is necessary to change the factory presetting. See "6.3. USING RS-232C COMMANDS."
A
Command
A
ABL Adjusting power consumption
B
BCP Transmitting the backup data to the DIGITAL Assy
BYG BY GAIN
C
CHM Clearing the hour meter
CNG Clearing MR NG information
B
CPC Clearing the power-on counter
CPD Clearing power-down information
CPM Clearing the pulse meter
CSD Clearing shutdown information
D
OSDS01 Turning on the on-screen display
OSDS00 Turning off the on-screen display
DRF Turning off the power for the drive system
DRN Turning on the power for the drive system
DW* Decreasing the adjustment value by *
E
EDWS00 Prohibiting writing of EDID data
EDWS01 Permitting writing of EDID data
C
F
F50 Video 50-Hz sequence
F60 Video 60-Hz sequence
F61 PC 60-Hz sequence
F70 PC 70-Hz sequence
TE
F72 Video 72-Hz sequence
L 13942296513
F75 Video 75-Hz sequence
FAJ Determining the adjustment values for the unit
FAY Turning Service Factory mode on
FAN Turning Service Factory mode off
G
GAJ Obtaining the adjustment values for the panel
GMM Switching the gamma levels
D
GNG Obtaining NG data of the MR
GNM Obtaining the serial No. of the MR
GPC Obtaining the P ON COUNTER value
GPD Obtaining power-down information
GPR Obtaining the PANEL REVISE data
GPM Obtaining the PULSE METER data
GPW Obtaining the PANEL W/B data
GS1 Obtaining the version data for each device
GS2 Obtaining data on various operations
GS6 Obtaining the any version
GSD Obtaining shutdown information
GSL Adjusting side mask G
E
www
F
170
1
http://www.xiaoyu163.com
2
Operation
x ao
y
. i
PDP-R05U
2
http://www.xiaoyu163.com
3
8
While the OSDSOI command is in force, the duration of on-screen display is
On-screen display is prohibited.
*: 1-9, 0 (0 means 10), or F (making the adjustment value the minimum)
Q Q
3 6 7 1 3
The GUI equivalent to that usually displayed when the power is turned on is displayed.
The GET-group commands are effective at any time, including during Standby mode.
Setting value: 000-007
u163
.
3
4
2 9 9 4 2 8
Remarks
1 5 0 5 8 2 9 9 4
m
co
4
9 9
2 8 9 9