Cleaning And Replacing The Filters; Cleaning The Brushroll; Cleaning The Pet Power Brush - Shark Navigator Lift-Away DLX UV440 Owner's Manual

CLEANING AND REPLACING THE FILTERS

CLEANING FILTERS
Regularly clean and replace the filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals. Allow
all filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being
drawn into electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Pre-Motor
Foam Filter
Felt Filter
HEPA
Filter
Pre-Motor (foam and felt):
With the dust cup removed, remove the
Foam and Felt Filters.
CLEAN PRE-MOTOR FILTERS EVERY
3 MONTHS.
REPLACING FILTERS
Follow the previous instructions for removing filters. The pre-motor filter should be replaced every
2.5 years. The HEPA filter should be replaced every 3 years.
Replacement
Replacement
Pre-Motor Foam & HEPA Filter
XHF80
Felt Filter Kit
XFF80
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
s h a r kc l e a n . c o m
Post-Motor (HEPA):
To access the HEPA filter, press the tab, tilt
the Filter Cover, and lift it off. Remove the
HEPA filter.
CLEAN HEPA FILTER EVERY YEAR.

CLEANING THE BRUSHROLL

1. Detach the pod from the floor nozzle.
2. Remove any blockages or buildup from the airways in the
nozzle. With scissors, carefully cut away any fibers, hair,
or string wrapped around the brushroll. Avoid damaging
or cutting the bristles.

CLEANING THE PET POWER BRUSH

Slide the locking latch forward and gently
lift off the cover. Carefully remove any
blockage or debris. With scissors, cut away
any hair or string wrapped around the
rotating bristle brush.
To reassemble, insert the tabs on the front
edge of the bottom cover into the matching
holes in the top half. Lower the cover and
press it down until it clicks into place.
s h a r kc l e a n . c o m