General Installation Instructions - Taylor SB25 Service Manual

General Installation Instructions

CAUTION: Only trained, authorized service
technicians should install the Blended Ice Machine.
Failure to comply will void the factory warranty.
The following are general installation instructions.
For complete installation instructions, please see the
Installation Checklist.
ALL WIRING AND PLUMBING MUST
CONFORM TO NATIONAL AND LOCAL CODES.
INSTALL POTABLE WATER CONNECTION
WITH ADEQUATE BACK-FLOW
PROTECTION TO COMPLY WITH
APPLICABLE NATIONAL, STATE AND
LOCAL CODES.
Site Preparation
Review the area where the unit will be installed
before uncrating the unit. Make sure that all possible
hazards to the installer, user, and the unit have been
addressed.
For Indoor Use Only: This unit is designed to
operate indoors, under normal ambient
temperatures of 70° - 75°F (21° - 24°C). The unit
has successfully performed in high ambient
temperatures of 104°(40°C) at reduced capacities.
This unit must NOT be installed in an area
where a water jet or hose can be used. NEVER use
a water jet or hose to rinse or clean this unit. Using a
water jet or hose on or around this equipment may
result in the electrocution of the user or damage to
the equipment.
Introduction
This unit must be installed on a level
surface to avoid the hazard of tipping. Extreme care
should be taken in moving this equipment for any
reason.
Two or more people are required to safely move this
unit. Failure to comply may result in personal injury
or equipment damage.
Uncrate the unit. Inspect the unit for damage. Report
any damage to the Taylor Factory immediately.
This unit is made using USA sizes of hardware. All
metric conversions are approximate.
Air Clearance:
No additional clearance is required on either side of
the unit for air inlet or discharge.
2" (50 mm) of clearance is required behind the unit
to allow for proper routing of the drainage hardware.
12" (304 mm) of air clearance is required above the
unit to allow for proper loading of ice into the ice
hopper.
Unit Preparation: Freezing Conditions
Storage
In order to prevent the freezing of water lines in the
unit, the drinking and rinse water lines shall be
drained prior to storage of the unit in a location
below freezing. If freezing of water in these lines
does occur, thaw the lines in normal ambient
conditions and check the water lines for signs of
damage before and after supplying water to the unit.
6
Model SB25