Error Message - Roland MUSIC ATELIER Series Owner's Manual

Error Message

Error Message
Copy Protected. Can't Save.
Write-Protected Media
Can't Save This Song.
Master Disk
Read Only File
No Media
Media Full
Unknown Media
Media Ejected
Damaged Media
Can't Read.
Can't Play.
No Rhythm
Memory Full
MIDI Buffer Full
Communication Error
A MIDI transmission error has occurred.
Memory Full
Memory Error
This is registration data of a type that is not supported.
USB over current
Meaning
To protect the copyright, this music file cannot be saved as SMF format.
The protect tab of the storage media is set to the Protect (write prohibit) position.
Move the tab to the Write (write permit) position and try the operation again.
You can only play the music files. It cannot be saved on a storage media
This storage media does not allow initialization or saving. Insert a different storage media and try the
operation again.
You cannot overwrite-save or delete a file on this storage media.
Storage media is not connected. Please connect storage media.
Saving is not possible because the storage media does not have enough space. Please use other
storage media that has been formatted by the ATELIER.
This storage media cannot be used. Please format it.
The storage media was disconnected while it was being accessed. Please try the operation again.
A damaged area was found on the storage media.
This data cannot be read.
Playback was halted because the song could not be read fast enough.
The song could not be read from the storage media fast enough for playback. Press the [Reset]
button, then press the [Play/Stop] button once again.
There is no rhythm in user memory.
The rhythm used by the selected registration was deleted from user memory, or its order was
changed.
The song data is excessively large, and cannot be loaded.
The performance data is excessively large, and cannot be loaded.
The data cannot be stored in user memory since user memory is full.
The ATELIER cannot deal with the excessive MIDI data sent from the external MIDI device. Reduce the
amount of MIDI data sent to the ATELIER.
A MIDI cable or computer cable has been disconnected. Connect it properly and securely.
The ATELIER is unable to handle the data that was sent.
Please send data that the ATELIER is able to handle.
Data transfer failed. Please transfer the data again.
Recording or editing is not possible because the memory of the ATELIER is full.
An error occurred in internal memory.
Please perform the operation again. If this indication appears even after you've repeated the
operation several times, please contact Roland service.
Registration data created by the AT-30, AT-50, AT-70, AT-80, or AT-90 is of a type that is not compatible
with the AT-350C.
* Registration data created by a unit from the AT-S or AT-R series is compatible with the AT-350C.
USB memory not supported by the ATELIER was connected. This USB memory cannot be used with
the ATELIER.
119