Programming The Remote Control - Sony WEGA KLV-S19A10 Operating Instructions Manual

Watching the TV

Programming the Remote Control

MTS/
POWER
MUTING DISPLAY SAP
POWER TV/
SAVING FREEZE VIDEO
RETURN WEGA GATE
FUNCTION
F1
F2
TOP MENU MENU GUIDE SLEEP
MODE
TV/SAT
SOUND PICTURE WIDE
Insert two size AA batteries
(supplied) by matching the
e and E on the batteries to
the diagram inside the
remote control's battery
compartment.
34
The remote control is preset to operate Sony brand video equipment.
Sony Equipment
DVD/VCR
1
SAT/Cable
Follow the steps below to program your TV's remote control to operate the
other video equipment.
2
Find the three-digit code for your equipment from the "Manufacturer's
Codes" listed on page 35. If more than one code number is listed, try
3
entering from the code listed first.
1 Press and hold the
program on the remote control and press the
The selected FUNCTION button (DVD/VCR or SAT/CABLE) will
flash.
2 Enter the three-digit manufacturer's code number using the --9
1
buttons while the button is lit, approximately 10 seconds.
3 Press button.
When the programming is correct, the selected FUNCTION button will
flash twice slowly, and when not, flashes five times quickly.
To check if the code works
Aim your TV's remote control at the equipment, and press the green
POWER button. If the equipment responds, the programming is completed.
If not, try the next code listed.
If no code is input within the above specified time, or an invalid or
incorrect code number is input, the remote control automatically goes
back to the previous setting.
In some cases, you may not be able to program your remote control to
operate other equipment. In such cases, use the equipment's own
remote control.
Dead batteries or removing the batteries may cause the programmable
codes to be lost and revert back to factory settings. Reprogramming the
codes may be necessary.
Programmable Code Number
601 (Sony Dream System)
801 (Sony Satellite Receiver)
FUNCTION button you want to
or
DISPLAY button simultaneously.