Programming The Remote Control - Sony WEGA KLV-S23A10 Operating Instructions Manual

Watching the TV
Programming the Remote Control
Tile remote control is preset to operate Sony brand video equipment.
DVD/VCR 601 (Sony Dream System)
SAT/Cable 801 (Sony Satellite Receiver)
Follow the steps below to program your TV's remote control to operate the
other video equipment.
Find the three-digit code for your equipment frolll the "Manufacturer's
Codes" listed on page 35. If more than one code number is listed, try
entering from the code listed first.
Insert two size AA batteries
(supplied) by matching the
In} and O on the batteries to
the diagram inside the
remote control's battery
conlpartnlent.
[] Press and hold the _) or _ FUNCTION button you want to
program on the remote control and press the _ button simultaneously.
The selected FUNCTION button (DVD/VCR or SAT/CABLE) will
flash.
[] Enter the three-digit manufacturer's code number using the (_)-(_)
buttons while the button is lit, approximately 10 seconds.
[] Press @ button.
When the programming is correct, the selected FUNCTION button will
flash twice slowly, and when not, flashes five times quickly.
To check if the code works
Aim your TV's remote control at the equipment, and press the green
PC)WE R button. If the equipment responds, the programming is completed.
If not, try the next code listed.
_ If no code is input within the above specified time. or an invalid or
incorrect code number is input, the remote control automatically goes
back to the previous setting.
_ In some cases, you may not be able to program your remote control to
operate other equipment. In such cases, use the equipment's owrq
remote control.
Dead batteries or removing the batteries may cause the programmable
codes to be lost and revert back to factory settings. Reprogramming the
codes may be necessary.
34