Setting Up The Channel List; Using Initial Setup - Sony WEGA KLV-S19A10 Operating Instructions Manual

Connecting the TV

Setting Up the Channel List

Using Initial Setup

30
After you finish connecting your TV, you need to run Initial Setup, which
automatically sets up available channels. The Initial Setup screen appears
when you turn on your TV for the first time after hooking it up. If you do not
want to set up the channels at this time, you can do it later by selecting the
Auto Program option in the Channel settings (see page 53).
The Auto Program feature does not apply for installations that use a
cable box.
The factory default setting for channel selection is Cable On. For
antenna connections, run the Auto Program again after selecting Cable
Off from the settings.
To run Initial Setup the first time you turn on your TV
1
Press POWER to turn on the TV.
The Initial Setup screen appears.
2
Press V or v to select the on-screen display language. Then press
The message "First please connect cable/antenna" appears.
By default, Auto Program is set to scan cable TV channels.
3
Press CH + to start Auto Program.
Auto Program automatically creates a list of receivable channels. When
finished, the lowest numbered channel is displayed. When all the receivable
channels are stored, the Show/Hide Channels settings appear.
To scan available VHF/UHF antenna channels instead of the cable TV
channels
1
Select Settings in WEGA GATE, then go to Channel settings.
2
Set Cable to Off.
3
Start Auto Program by pressing CH +.
To perform Auto Program again, follow the above instructions.
Depending on your signal source, be sure to set Cable to On or Off
accordingly (see page 53).
The Initial Setup menu will appear each time the TV is turned on until
you complete the scanning for the available channels.
.