Diagnostic Leds Starting With Ar J2.96, E3.01 And B3.06; Act / Lnk Leds For The Rj45 Interface - B&R 4PP065.0571-B00 Technical Documentation Manual

3.1.2 Diagnostic LEDs starting with AR J2.96, E3.01 and B3.06

LED Color Status
Status see "Table 6: 4PP065.0571-X74F - Status LED blink code" on page 7
User Green On / Off
X2X Orange On
CF Orange On
Table 5: 4PP065.0571-X74F - Diagnostic LEDs starting with AR J2.96, E3.01 and B3.06
Blink codes (200 ms pattern)
Because blink codes can only signal one error at a time, errors with higher priority take precedence. Fatal errors
have a higher priority than less significant errors (e.g. low battery capacity).

3.1.3 ACT / LNK LEDs for the RJ45 interface

There are two additional LEDs for the Ethernet interface.
LED Color Status
ACT Orange On
Blinking
LNK Green On
Data sheetV 1.00 4PP065.0571-B00
Description
LED operable by the user (with the AsHW library)
Module sending data via the X2X Link interface
CompactFlash card being accessed
Description
Error / Reset
No errors, normal operation
Battery not installed or battery capacity too low
CompactFlash media not found
Reserved for future blink codes
Table 6: 4PP065.0571-X74F - Status LED blink code
Figure 4: 4PP065.0571-X74F - ACT/LNK LEDs for the RJ45 port
Description
No Ethernet activity on the bus
Ethernet activity on the bus
A link to the remote station has been established.
Table 7: 4PP065.0571-X74F - ACT/LNK LEDs for the RJ45 port
Fully assembled device - Technical data
ACT
(orange)
LNK
(green)
7