Table of Contents
Advertisement
Technical Data
Battery Voltage*
Battery Capacity
Charge Time Max
Battery Run Time Max
Motor
Max Water Inlet Temperature
Removable Bucket Capacity
High Pressure Hose Length
Soap Dispenser
Attachment Capacity
Max Water Inlet Pressure
Max Rated Flow
Max Flow
Pressure Select Technology
Max Pressure
Weight (without battery)
*Initial no-load voltage, when fully charged, peaks at 40 volts; nominal voltage
under typical load is 36 volts.
†
Sold separately.
Unpacking
Carton Contents
• Water bucket assembly
• Bucket lid
• Base unit
• Trigger gun
• Spray wand
• Four (4) Quick-Connect nozzles (0º, 15º, 25º, and 40º)
• Needle clean-out tool
40 V D.C.
4.0 Ah (model iBAT40
)
†
5.0 Ah (model iBAT40XR
)
†
6.0 Ah (model iBAT40XRP
†
3 hours (using iBAT40 with
iCHRG40
)
†
3.5 hours (using iBAT40XR
with iCHRG40
)
†
5 hours (using iBAT40XRP
with iCHRG40
)
†
21 min (using iBAT40
)
†
31 min (using iBAT40XR
)
†
35 min (using iBAT40XRP
)
†
600 W brushless
104ºF/40ºC
5.3 gal (20 l)
20.3 ft (6.2 m)
8.5 fl oz (250 ml)
0.7 MPa
0.79 GPM
1 GPM
LOW/500 PSI
MEDIUM/650 PSI
HIGH/800 PSI
1160 PSI
20 lbs (9.1 kg)
• Soap dispenser attachment
• Trigger gun holder
• High-pressure hose
• Garden hose adapter (female coupler)
)
• Manual with registration card
1. Carefully remove the pressure washer and check to see
that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new cordless
pressure washer. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils,
or small parts. These items can be swallowed and pose a
suffocation risk!
m
WARNING!
Do not insert the battery until assembly is
complete. Failure to comply could result in accidental starting
and possible serious personal injury.
Assembly
1. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 1).
Fig. 1
2. Open the box, take out the bucket lid, bucket and the
base unit (Fig. 2).
7
+ Sun Joe
customer service center at
®
®
Advertisement
Table of Contents
