sunjoe SPX6001C-CT Operator's Manual page 13

Fig. 18
Garden hose
Garden hose adapter
Water inlet
5. Attach garden hose to water supply (Fig. 19).
m
WARNING!
Water that has flowed through back flow
preventers is considered to be non-potable.
m
WARNING!
The water supply must not exceed 0.7Mpa.
Fig. 19
Connect to water supply
Garden hose
6. If only using the base unit, turn the water supply tap on
completely.
7. Push the safety lock on the spray gun handle, then press
the trigger for a few seconds until the water flow is steady.
Operating the pressure washer in this manner will allow
air to escape and discharge residual pressure in the hose
(Fig. 20).
Fig. 20
8. Keeping the trigger pressed, turn on the unit by pressing
the On/Off button on the control panel. Using the "Pressure
Select" feature, you can also choose from three different
Base unit
pressure settings by pressing the + or - button on the right
side of the control panel (Fig. 21).
Fig. 21
NOTE: This machine is equipped with 3 selectable power/
pressure levels. See table below for detailed specs.
Power
Low
Medium
High
9. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts off when the trigger is released.
13
Trigger
Control panel
Light
Rated flow
indication
– Off
0.66 GPM
– Off
– On
– Off
0.75 GPM
– On
– On
– On
0.79 GPM
– On
– On
Safety lock
Rated
pressure
507 PSI
650 PSI
800 PSI