Levelling; Fitting The Plinth; Customer Care - Rangemaster Classic Deluxe 110 Dual Fuel with FSD User Manual

Levelling

It is recommended that you use a spirit level on a shelf in one
of the ovens to check for level.
Place the cooker in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker use the
13 mm spanner to turn the adjusting nuts at the front bottom
corners of the cooker. To set the front feet turn the bases to
raise or lower.
To refit the drawer, pull the side rails fully out (Fig.7-18).
Carefully move the drawer back between the rails and rest it
on the side rails.
At each side, hold the front of the drawer and pull the side
rail forward so that the clips click into position, holding the
drawer to the side rails (Fig.7-19).

Fitting the Plinth

Fit the inner plinth to the bottom front of the cooker using
the five screws provided (Fig.7-20).
Fit the outer plinth (Two screws - one at each end) to the
inner plinth (Fig.7-21). The height of the outer plinth can be
adjusted by sliding it up or down via the slotted hole.

Customer Care

Installer: Please complete your details in this Guide, inform
the user how to operate the cooker and hand oven the
instructions.
Thank you.
Check the appliance is electrically safe when you have finished.
INSTALLATION
Make sure the inner
rail is forwards
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Inner plinth
31
Fig.7-18
Fig.7-19
Fig.7-20
Fig.7-21
Outer plinth
Outer plinth fixing screw