Table of Contents
Advertisement
Polishing
WARNING!
ENSURE THE TOOL IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
CHANGING BONNETS.
1 Remove the application bonnet
and replace with a clean
polishing bonnet.
2 Insert the battery, hold the
polisher on the surface and start
the tool.
3 Allow the motor to reach
maximum speed and move the
polisher using long sweeping
strokes in a crisscross pattern.
Note:
Do not apply excessive force to the polisher. Allow the polisher to do
the work.
4 Once the entire surface has been polished and all polishing compound
is removed using the polishing bonnet, you will be left with a swirl-free
polished surface.
Operation Tips
It is best to start with large flat surfaces and ending with the hard-to reach
areas.
Never force the polisher. The weight of the tool supplies adequate pressure,
to do the work. Applying additional pressure will slow the motor, rapidly wear
the bonnet, and greatly reduce the polisher speed. This will slow the polishing
rate and produce an inferior quality surface.
CAUTION:
Excessive pressure will overload the motor, causing possible
damage to the polisher by overheating the motor; or damage to the surface.
CAUTION:
DO NOT USE WITH ABRASIVE COMPOUNDS
AS THIS WILL VOID THE WARRANTY.
I
0
5. CLEANING THE BONNETS
The included application and polishing bonnets can be re-used. For maximum
life and performance, the bonnets should be cleaned after each use.
1 Remove the bonnets from the
tool and hand wash under warm
water.
2 Allow the bonnets to air dry
before fitting to the polisher.
Note:
If needed, the bonnets can be machine washed in cold water with a
small amount of detergent.
PXBPS-254
Advertisement
Table of Contents
