Sony BRAVIA 4-106-868-13(1) Operating Instructions Manual page 7

If a message appears for you to confirm
the aerial connection
No digital or analogue channels were
found. Check all the aerial/cable
connection and then press
tuning again.
8
When the "Programme Sorting" menu
appears on the screen, follow the steps of
"Programme Sorting" (page 42).
If you do not change the order in which
the analogue channels are stored on the
TV, press RETURN to go to step 9.
9
Quick Start
Do you want to enable Quick Start?
TV turns on more quickly but standby power consumption is increased.
Yes
For details, see page 37.
10
Control for HDMI
Do you want to enable control for compatible
HDMI devices?
Choosing "Yes" will increase
standby power consumption.
Yes
For details, see page 29.
Following this step, GUIDE Plus+ setting
screen appears only when GUIDE Plus+
is available.
11
Press .
The TV has now tuned in all the available
channels.
~
• When a digital broadcast channel cannot be
received, or when selecting a country in which
there are no digital broadcasts in step 4, the time
must be set after performing step 8.
to start auto-
No
No
To tune the TV for Cable connection
1
Press .
2
Press F/f to select "Quick Scan" or "Full
Scan", then press
"Quick Scan": channels are tuned
according to the cable operator
information within the broadcast signal.
Recommended setting for "Frequency",
"Network ID" and "Symbol Rate" is
"Auto."
This option is recommended for fast
tuning when supported by your cable
operator.
If the "Quick Scan" does not tune, please
use the "Full Scan" method below.
"Full Scan": All available channels are
tuned and stored. This procedure may take
some time.
This option is recommended when "Quick
Scan" is not supported by your cable
provider.
For further information about supported
cable providers, refer to support web site:
http://support.sony-europe.com/TV/
DVBC/
3
Press f to select "Start", then press
The TV starts searching for channels. Do
not press any buttons on the TV or
remote.
~
• Some cable providers do not support "Quick
Scan." If no channels are detected using "Quick
Scan", perform "Full Scan."
To set-up GUIDE Plus+ system (only
when GUIDE Plus+ system is
available)*
* Condition you can set-up this feature:
– in UK, Italy, Germany or Spain.
– you can receive digital broadcasting.
– when "Antenna" is selected in step 7 of " 5:
Performing the initial set-up."
1
Enter postal code of region you live using
F/f/G/g/+.
~
• Enter from the left, when the postal code is
fewer than seven digits.
.
.
7
(Continued)
GB