Operation; Loading Film - Sony UP-DF500 Instructions For Use Manual

Operation

Loading Film

Recommended Film
The following blue thermal film is made especially for
the UP-DF500.
UPT-517BL Blue Thermal Film printing pack
Contains blue thermal transparent film.
125 sheets of 14 × 17 inch film
Be sure to use film made expressly for the UP-DF500. If
you use other film, the quality of the printout cannot be
guaranteed. Use of another type of film may also cause
malfunction of the unit.
Loading Film
Proceed as follows to load film sheets.
If you use the unit immediately after purchase, start
operations from step 2.
To confirm the remaining amount of film
The remaining film confirmation indicator allows you to
confirm the amount of film remaining.
When this indicator is not lit, film has run out. Load new
film.
Remaining film confirmation window
Notes
• Hold the film using the aluminum damp-proof bag. Do
not touch the film directly. Dust, finger prints, or sweat
are likely to cause unsatisfactory printing.
• Hold both sides of the film tray and tray cover tightly
when handling the film tray.
1
Push the EJECT TRAY button on the front panel.
The film tray is partially ejected.
Notes
• You can replace film without pulling out the film
tray completely out. However, if you want to pull
out it completely, hold both sides of the film tray
and film tray cover firmly.
• The film tray can not be ejected while printing or
when the covers are open.
2
Open the film tray cover by putting your fingers in
the grooves on both sides of the film tray, and
pulling it upward in the direction of the arrow.
Pull it upward in the direction of the arrow,
putting your fingers in the grooves.
Note
If the old printing surface protection sheet remains
in the film tray, remove it.
3
Remove the aluminum damp-proof bag from the
film carton.
Push the EJECT TRAY button
Loading Film
11