Sony DSR-45/45P Operating Instructions Manual page 42

Recording
To video equipment without a DV jack
You can connect this unit to video equipment without
a DV jack. Use this unit as a recorder as follows.
Monitor
Player
Connect one of the following as a video cable: video
cable (3BNC y 3BNC), S-video cable, or 75 Ω
coaxial cable.
Use a conversion cable for the audio connection,
depending on types of audio output connectors on the
player (see page on 23 (GB)).
Notes
• During recording, analog input signals can be output
simultaneously from the DV jack for backup. Set DV
42
(GB) Chapter 2 Playback and Recording
S-video output
Video output
Audio output
Component output
S-video cable (not supplied)
75 Ω coaxial cable (not supplied)
Audio cable (phono jack) (not supplied)
Video cable (3BNC y 3BNC) (not supplied)
Monitor
Audio input
Video input
DSR-45/45P (recorder)
(rear panel)
EE OUT on the VTR SET menu to ON.
For details on the VTR SET menu, see "VTR SET menu"
on page 90 (GB).
• If you connect the output connectors of this unit to
the input connectors of the player, a humming noise
may be generated or the image may be distorted. If
these phenomena occur, set the INPUT SELECT
selector to a position where a signal is not currently
being input, or disconnect the cables.
Phono jack cable
(not supplied)
Phono
jack cable
(not
supplied)
: Signal flow