Infortrend EonStor GSa 5000 Series Hardware Manual page 40

3. Insert the SFP module into one of the system host ports. The module will snap into place.
NOTE: The drawing of the controller is for reference only. Look for the actual system host ports in your
GSa 5000 system.
4. Remove the two protective caps from the LC-to-LC type cable. Save the protective caps for future
use.
5. Insert the LC-to-LC cable to the SFP transceiver module already connected to the system. You can
hear a clicking sound, securing the cable in place.
NOTE: The drawing of the controller is for reference only. Look for the actual system host ports in your
GSa 5000 system.
6. Remove the protective caps on the other end of the cable, then connect to an SFP transceiver
module on a Fibre Channel switch port or a Fibre Channel host bus adapter (HBA) port.
2-18
LC-to-LC cable
Protective caps
Chapter 2: Hardware installation