NOTES:
•
•
WARNING!
•
•
•
CAUTION! Keep your body away from the moving parts of the system.
1-8
The PSUs have specific installation orientations for upper and lower cooling module slots. Refer to
the label at the back of the expansion.
There are two upper temperature thresholds: one for event notification and the other for triggering
high fan rotation speed. You can change the preset values for event notification using the firmware-
embedded configuration utility. Refer to the firmware operation manual for details.
If any of the LEDs lights up in red, please contact your local vendor to request for a replacement
immediately.
When removing the PSU, pull the module for about 3 inches then wait for at least 10 seconds before
removing the whole module from the enclosure.
DO NOT run the system with faulty cooling module(s) as it may cause disruption of the airflow
resulting in overheating.
Chapter 1: Product introduction