Infortrend EonStor GSa 5000 Series Hardware Manual page 26

Assembling the slide rail kit
To assemble the slide rail kit:
1. Determine the position where the system will be installed to the front and rear rack posts, then
insert the cage nuts into the designated holes on the front rack posts.
9.0 mm M5
2. Loosen the four screws on the slide rails then adjust its length. After the length adjustment, secure
the slide rails to the front and rear posts with the truss head screws.
9.0 mm M5
3. Attach the inner glides to both sides of the enclosure using the flathead screws no. 6-32.
2-4
Front rack post
No. 6-32
Unit boundary
M 5 cage nut position
Unit boundary
Inner glide rail
Rear rack post
9.0 mm M5
No. 6-32
Chapter 2: Hardware installation
9.0 mm M5