Siemens SIRIUS 3RW52 Manual page 123

"Delete PIN" procedure
1. Select the "Delete PIN" menu.
2. Log in using the current 4-digit PIN and confirm your entry with "OK".
If the entry is correct, the display of the 3RW5 HMI High Feature will show the user
information "Log in was successful". Confirm with "OK".
After confirmation, the 3RW5 HMI High Feature returns to the "Local access protection"
menu.
The current PIN has been deactivated and deleted. Define a new PIN.
Parameters
Parameter
Local access protection
This menu can only be displayed if a PIN has been defined.
1)
This menu can only be seen after logging in with an active PIN.
2)
Result
With the PIN, you can protect the 3RW5 HMI High Feature from unauthorized access. The
menus of the 3RW5 HMI High Feature can still be viewed, but parameters cannot be
changed with local access protection activated.
The PIN remains even after the power supply has been interrupted.
Note
Reset PIN.
You can reset the access protection to the factory setting with the master RESET key on the
rear of the 3RW5 HMI High Feature.
Protect the master RESET key from unauthorized access.
SIRIUS 3RW52 Soft Starter
Manual, 01/2019, A5E35630451002A/RS-AD/004
Description
Define PIN PIN is set up and active.
•
•
Change PIN Existing PIN is changed.
1)
Delete PIN PIN is deactivated and deleted.
1)
Auto Log Off time
1)
•
•
Log on Remove the local access protection by logging
1)
on with your 4-digit PIN.
If you issue a control command or want to
change a parameter when access protection is
enabled, you will receive an entry prompt for the
current PIN.
Log out Log out of your current session. Access
2)
protection is activated again.
7.9 High Feature 3RW5 HMI
Empty (factory setting)
4-digit PIN
0 min = deactivated (factory setting)
Setting range: 0 ... 60 min
Functions
123