Initial Calibration; Operation - OHAUS Catapult 1000 Series User Manual

EN-2
Battery Installation
Install the three "C" size (LR14) batteries (not included) with polarity as shown in the battery compartment.
2.3 Levelling the Instrument
To level the instrument, adjust the feet so the bubble is centered in the circle of the level indicator. Be sure the equipment is
level each time its location is changed.

2.4 Initial Calibration

For best results, the instrument's calibration should be checked prior to first use. If adjustment is needed, refer to the Calibration section of
the instruction manual.

3. OPERATION

3.1 Overview of Display, Home Screen
CONTROLS
Button
Primary Function
(Short Press)
Secondary Function
(Long Press)
On/Zero
Off
ON/ZERO
Turns scale ON.
If scale is On:
Sets zero.
Simulates a tare operation.
Off
Turns scale off.
Cat1000 Series Scales
Units
Cal
On/Zero
Off
Units
Cal
UNITS
Changes the weighing unit.
Enters Dynamic Weighing Mode.
Initiates countdown in Dynamic Weighing mode.
Cal
Initiates calibration process.