Sony RDR-GX300 Operating Instructions (RDR-GX300 DVD Recorder) Operating Instructions Manual page 25

If you connect the satellite receiver or cable
box to the recorder's antenna input (page 14),
select "Ch2," 'Ch3," or "Ch4" and press
ENTER, then go to step 13. See the
instructions supplied with your cable box to
confirm the cable box's antenna output
channel.
11
Select whether or not you have a cable
connection.
EASY SETUP
Select the way in which you will receive channels.
Antenna
Cable
If you use an antenna only (no cable TV),
select "Antenna."
If you use a cable connection without a cable
box, select "Cable."
12
Press ENTER.
The Tuner Preset function automatically starts
searching for all of the receivable channels
and presets them.
EASY SETUP
Searching for receivable channels.
Please wait.
To set the channels manually, see page 71.
After the Tuner Preset is finished, the Setup
Display for selecting the aspect ratio of the
connected TV appears.
13
Select the setting that matches your TV
type.
EASY SETUP
Select your TV screen type.
16 : 9
4 : 3 Letter Box
4 : 3 Pan Scan
Tuner Preset 4/6
Tuner Preset 4/6
Ch45
TV Type 5/6
"4:3 Letter Box": For standard TVs.
Displays "wide screen" pictures with bands
on the upper and lower sections of the screen.
"4:3 Pan Scan": For standard TVs.
Automatically displays "wide screen"
pictures on the entire screen and cuts off the
sections that do not fit.
"16:9": For wide-screen TVs or standard TVs
with a wide screen mode.
For details, see "TV type" on page 74.
14
Press ENTER.
The Setup Display for selecting the type of
jack used to connect to your amplifier
(receiver) appears.
EASY SETUP
Is this recorder connected to an amplifier (receiver)?
Select the type of jack you are using.
LINE OUT(R-AUDIO-L)
Yes :
Yes : DIGITAL OUT
No
15
Select the type of jack (if any) you are
using to connect to an amplifier (receiver),
and press ENTER.
If you did not connect an AV amplifier
(receiver), select "No," then go to step 19.
If you connected an AV amplifier (receiver)
using just an audio cord, select "Yes: LINE
OUT (R-AUDIO-L)," then go to step 19.
If you connected an AV amplifier (receiver)
using either a digital optical or coaxial cord,
select "Yes: DIGITAL OUT."
16
Select the type of Dolby Digital signal you
wish to send to your amplifier (receiver).
EASY SETUP
Dolby Digital
D-PCM
Dolby Digital
If your AV amplifier (receiver) has a Dolby
Digital decoder, select "Dolby Digital."
Otherwise, select "D-PCM."
Audio Connection 6/6
Audio Connection 6/6
,continued
25