Makita HP332D Technical Information page 9

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Drill chuck
(HP332D, DF332D)
ASSEMBLING
1. After replacement with fresh Keyless drill chuck 10, assemble Gear assembly as illustrated in Fig. 13.
Fig. 16
(11)
Fig. 17
(4)
(6)
Fig. 18
(1)
(11)
Long arm of
(9)
Hex wrench 8
(3)
5. Join Gear assembly (11) to
motor section, while engaging
its gears with Rotor's gear.
(3)
See upper left illustration in
in Fig. 16.
6. Mount Housing set R,
by fastening with eight 3x16
Tapping screws.
See upper right illustration in
in Fig. 16.
7. Set Keyless drill chuck 10, by
turning clockwise, until it sits
on Spindle of Gear assembly (11).
See lower left illustration in
in Fig. 16.
1. Set the Speed change lever (4) to 1.
2. Set the machine to Drill mode.
3. Inserting the long arm side of Hex
wrench 8, grip it with Keyless
drill chuck. See fig. 17.
4. Set the R/F Change lever (6) to forward mode.
5. Grip the short arm side of Hex wrench 8
firmly with vise.
6. Closely apply the grip end of Housing
set R to the edge of Work bench, to accept
the machine which is swung counter
clockwise.
7. Slowly pull the Switch trigger to rotate Spindle,
until the Motor is locked.
<Note > Pull the Trigger so that Spindle's rotating
reaches full speed in one second.
Important: Be sure to release the Switch trigger
just after Spindle is locked.
P 9/ 20