Makita HP332D Technical Information page 20

C
ircuit diagram
Fig. D-3
LED Light circuit can be singly replaced, separating from Controller.
Poly olefin
tube
Twisted wire
Twisted wire
Controller
C
ircuit diagram
Fig. D-4
< Note >
The lead wire of LED light circuit
have to be put under Stator's lead
wires (orange), (white), (blue).
Put Non-insulated sleeves coated with
Poly olefin tube, to the illustrated area
designated with gray color.
Replacement of LED Light Circuit
1. Cut the lead wires to the proper
length, so that Non-insulated
sleeves can be put to the space
between Switch and Stator.
And twist the wires.
Non-insulated
sleeve
2. Pass lead wires through Non-
insulated sleeves.
And then, coat the Non-insulated
sleeves with Poly olefin tubes.
edge of Poly olefin tube
Non insulated
sleeve
edge of Poly olefin tube
Wiring of Replaced LED light circuit
Non insulated sleeve
Rib B
3. Press Non-insulated sleeves coated with
Poly olefin tubes.
So, the fresh LED light circuit is connected
to the lead wires of Controller.
Press
Controller
at least 2 mm 1. Use Poly olefin tube of
2. Cut Poly olefin tube at
at least 2 mm
Stator
P 20/ 20
Press
Press
which Inner diameter is
4mm, for coating Non-
insulated sleeve.
least 4mm longer than
Non insulated sleeve.