Sony DVP-S525D Operating Instructions Manual page 56

Controlling the TV or the AV Receiver (Amplifier) with the Supplied Remote
When you set the TV/DVD•AV CENTER switch to TV,
you can control your TV using the keys below.
TV/
DVD•AV CENTER
switch
1 2
Number buttons/
4 5
ENTER
7 8
0
?
By pressing You can
1/u (POWER) Turn the TV on or off
Select the input source for the TV
TV/VIDEO
between the TV and VCR
Select the input source for the TV
TV/DVD*
between the TV and CD/DVD player
Adjust the volume of the TV
VOL
Select the program position of the TV
TV PROG
Switch the wide picture on or off
WIDE MODE
Select the program position of the TV
Number buttons
and ENTER
* If you connect the player to the TV via the EURO AV OUT
connectors, the input source for the TV is set to the player
automatically when you start playback or press any button
except for 1/u (POWER). In this case, press TV/DVD to return
the input to the TV.
Notes
• Depending on the TV, you may not be able to control your TV
or to use some of the buttons above.
• If you use number buttons to select program position of the TV,
press ? followed by the number buttons for two-digit
numbers.
56
1/u (POWER)
TV/DVD
3
6
WIDE MODE
9
TV/VIDEO
TV PROG
VOL
ENTER
Controlling an AV receiver (amplifier)
with the remote
1
Slide the TV/DVD•AV CENTER switch to
DVD•AV CENTER.
2
Hold down 1/u (POWER), and enter your AV
receiver's manufacturer's code (see the table
below) using the number buttons. Then release
1/u (POWER).
Manufacturer
Sony
Denon
Kenwood
Onkyo
Pioneer
Sunsui
Technics
Yamaha
–
* By setting the code number 90, you can adjust
the volume of the TV even if the TV/DVD•AV
CENTER switch is on the DVD•AV CENTER
side, if you do not control an AV receiver
(amplifier) with the remote.
Code numbers of controllable receivers
(amplifiers)
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
receiver (amplifer).
You can also change the sound volume of the AV receiver
(amplifier) using VOL.
1 2
4 5
7 8
0
Note
Depending on the AV receiver (amplifier), you may not be able to
control your AV receiver (amplifier).
Code number
91(default), 88,
89
84, 85, 86
92, 93
81, 82, 83
99
87
97, 98
94, 95, 96
90*
3
6
9
VOL