Table of Contents
Advertisement
The following instructions demonstrates the assembly procedure:
RJ-45 cable without cable connector boots plug cover (soft plastic) is recommended
as indicated in Figure 3-9.
1. Insert the sealing nut, seals, and support into the cable assembly.
(Cable OD range: 5.0 ~ 6.5 mm.)
2. Connect the sealing nut on the half-finished goods and screw tightly.
(Sealing nut torsion value range: 5~15 kgf-cm)
Please refer to Figure 3-10 for details.
Figure 3-9: Suitable cables for RJ45 connector
Figure 3-10 : Installing Procedure of Communication Connectors on the Cabinet
27
Installation
Advertisement
Table of Contents
