Table of Contents
Advertisement
Installation
Please read the following instructions for attaching DC terminals :
• It is important to choose the proper size for DC cable.
• DC cable adapter must be assembled as depicted in Figure 3-6.
• DC connectors are applied to DC Terminals connection as seen in Figure 3-7.
• It is important to choose the correct DC connectors for positive terminal and
negative terminal. Please refer to Figure 3-6 and Figure 3-7.
• Please follow the instructions below to assemble the DC connector.
Please confirm wire stripping of copper is enough for this DC connector which
seizes the cable firmly.
There are two parts of the DC cable adapter.
1. Put the stripped wire into the DC cable adapter
2. Lock it.
3. Attach the bottom part of the DC cable adapter to the upper part of the DC
cable adapter.
4. Rotate and tighten them.
Figure 3-6 depicts the procedure listed above.
- Please make sure to choose the correct cable for positive terminal and
negative terminal.
- Please note that male connectors are for positive terminals on both sides of
the cable.
ATTENTION
24
Advertisement
Table of Contents
