Makita RP1110C Technical Information page 6

W
iring diagram
Model RP0910
Pass lead wire of noise suppressor
with transparent sheath, between
boss and rib.
A : View from top
B : View from
Noise
suppressor
A : View from top
Boss
Rib
Boss
knob R side
B : View from knob R side
Lead wire of noise suppressor
with transparent sheath
Put insulated terminal
and slacked lead wires
in this place as per
the illustration.
Sponge
Sponge for dust protector
installed in knob R
Pass lead wires to be connected to
switch, as per the illustration.
Fix lead wires to be connected to
terminal block, with lead holder.
And set the lead wires of noise suppressor
inside of the machine (armature side), when
fixing them with lead holder.
Set noise suppressor as per
the illustrated position.
When noise suppressor without
grounding wire (covered with
transparent sheath) is used,
cover the noise suppressor
with sponge.
Pass lead wire of support (field)and
the same of noise suppressor with
transparent sheath, in the groove.
Lock
off button
Wiring in knob R
P 6 / 6
Trigger