Battery Charger Connection; Battery Installation - Generac Power Systems SG30 Owner's Manual

Figure 8.2 - Generator Grounding Lug (typical)

BATTERY CHARGER CONNECTION

The generator has been equipped with a 10 Amp
battery charger installed. This charger needs to be
plugged into an appropriate 120VAC 15 amp outlet.
Standby Generator Sets
Installation
GROUNDING
LUG
8-5

BATTERY INSTALLATION

DANGER

Standby generators installed with automatic
transfer switches will crank and start automati-
cally when NORMAL (UTILITY) source voltage is
removed or is below an acceptable preset level.
To prevent such automatic start-up and pos-
sible injury to personnel, do not connect battery
cables until certain that; the AUTO/OFF/
MANUAL switch is in the OFF position; the 15A
fuse has been removed from the control box
(see Start-up Check List); normal source voltage
at the transfer switch is correct and the system
is ready to be placed into operation.

Storage batteries give off explosive hydrogen
gas. This gas can form an explosive mixture
around the battery for several hours after charg-
ing. The slightest spark can ignite the gas and
cause an explosion. Such an explosion can shat-
ter the battery and cause blindness or other
injury. Any area that houses a storage battery
must be properly ventilated. Do not allow smok-
ing, open flame, sparks or any spark producing
tools or equipment near the battery.

Battery electrolyte fluid is an extremely caus-
tic sulfuric acid solution that can cause severe
burns. Do not permit fluid to contact eyes, skin,
clothing, painted surfaces, etc. Wear protective
goggles, protective clothing and gloves when
handling a battery. If fluid is spilled, flush the
affected area immediately with clear water.

Do not dispose of the battery in a fire. The bat-
tery is capable of exploding.

Do not open or mutilate the battery. Released
electrolyte can be toxic and harmful to the skin
and eyes.