Generac Power Systems iX 2000 Operator's Manual
Digital inverter generator 005793-0
Hide thumbs
Also See for iX 2000:
- Owner's manual (60 pages) ,
- Quick setup manual (12 pages) ,
- Specification (2 pages)
Related Manuals for Generac Power Systems iX 2000
Summary of Contents for Generac Power Systems iX 2000
- Page 1 2000 Digital Inverter Generator Operator's Manual Grainger stock #: 4KCD7 MODEL: 005793-0...
-
Page 2: Table Of Contents
Table of Contents Portable Generator System ACCESSORY BOX Accessory Box ..........Inside Front Cover Introduction ................1 Check all contents. If any parts are missing or damaged locate an authorized dealer at 1-888-436-3722. Read this Manual Thoroughly ..........1 Contents include: Safety Rules ................1 •... -
Page 3: Introduction
NOTE: Notes contain additional information important to a procedure Thank you for purchasing this model by Generac Power Systems, and will be found within the regular text body of this manual. Inc. This model is a compact, high performance, air-cooled,... - Page 4 IMPORTANT SAFETY INSTRUCTIONS Portable Generator System SAVE THESE INSTRUCTIONS – The manufacturer suggests that these rules for safe operation be copied and posted near the unit's installation site. Safety should be stressed to all operators and potential operators of this equipment. EXHAUST &...
-
Page 5: Standards Index
IMPORTANT SAFETY INSTRUCTIONS Portable Generator System • Wipe up any fuel or oil spills immediately. Ensure that no MODEL NO: combustible materials are left on or near the generator. Keep the area surrounding the generator clean and free from debris and SERIAL NO: keep a clearance of five (5) feet on all side to allow for proper ventilation of the generator. -
Page 6: Section 1 - General Information
Section 1 – General Information Portable Generator System SPECIFICATIONS Figure 2 - Unit Identification Engine Type ......Single Cylinder, 4-Stroke Engine Size . -
Page 7: Section 2 - Operation
Section 2 – Operation Portable Generator System Figure 3 - Control Panel 6. The National Electric Code (NEC) requires the frame and external electrically conductive parts of the generator be properly connected to an approved earth ground. Proper grounding of the generator will prevent electrical shock in the event of a ground fault condition in the generator or in connected electrical devices. -
Page 8: Adding Loads
Section 2 – Operation Portable Generator System Figure 5 - Prime Fuel System 2. DO NOT overload the generator; if the red “overload” LED lights up and the accessories attached to the generator stop operating, stop the engine and reduce the load to the generator. -
Page 9: Using The Flexpower™ Switch
Section 2 – Operation Portable Generator System USING THE FLEXPOWER™ SWITCH Figure 7 - Turn Off Fuel When the accessories connected to the generator are going to be used intermittently (such as a hand drill), the FlexPower™ switch can be pushed to the “ON” (I) position. This will lower the TURNING THE FUEL OFF generator engine speed when loads are not being applied, saving fuel, reducing engine wear and extending runtime. -
Page 10: To Fill The Fuel Tank
Section 3 — Maintenance Portable Generator System TO FILL THE FUEL TANK TO ADD ENGINE OIL TO THE CRANKCASE 1. Remove the fuel tank cap. 1. Place the unit on a firm, level surface. 2. Remove the Left Side Service Cover. Figure 8 - Fuel Tank Cap 3. -
Page 11: Generator Maintenance Schedule
Section 3 — Maintenance Portable Generator System NOTE: The air filter is located behind a cover for the air box (Figure 10). Push the tab on the bottom of the air box up wards to release the DO NOT use a garden hose to clean the generator. Water cover. -
Page 12: Changing The Fuel Filter
Section 3 — Maintenance Portable Generator System NOTE: 3. Install the new spark plug into the cylinder head. Tighten the spark plug to 15 ft/lb. To make draining the oil easier, a 6” length of vinyl (PVC) hose 4. Replace the spark plug lead, making sure it is fully seated. with an inside diameter of 1.25”... -
Page 13: Section 4 - Troubleshooting
Section 4 — Troubleshooting Portable Generator System 4.1 TROUBLESHOOTING GUIDE PROBLEM CAUSE CORRECTIVE ACTION Engine won't start. 1. No fuel in tank. 1. Add fuel to tank. 2. Fuel valve turned off. 2. Turn fuel valve on. 3. Defective spark plug. 3. -
Page 14: Section 5 - Warranty
Generac cannot deny warranty solely due to the lack of receipts. As the generator owner, you should be aware that Generac may deny any and/or all warranty coverage or responsibility if your generator, or a part/component thereof, has failed due to abuse, neglect, improper maintenance or unapproved modifications, or the use of counterfeit and/or "grey market"... -
Page 15: Emission Control System Warranty
Such use voids this ECS Warranty and shall be sufficient grounds for disallowing an ECS Warranty claim. Generac shall not be held liable hereunder for failures of any warranted parts of Generac equipment caused by the use of such an unapproved, add-on, modified, counterfeit and/or "grey market"... - Page 16 SERIES PORTABLE GENERATORS For a period of two years from the date of original sale, Generac Power Systems, Inc. (Generac) warrants its iX Series generators will be free from defects in materials and workmanship for the items and period set forth below. Generac will, at its option, repair or replace any part which, upon examination, inspection and testing by Generac or a Generac Authorized Warranty Service Dealer, is found to be defective.
Need help?
Do you have a question about the iX 2000 and is the answer not in the manual?
Questions and answers
What oil should I use in my iX2000 that is 20 yeas old and has 500+ hrs.
For a 20-year-old Generac iX2000 with over 500 hours of use, use SAE 5W-30 oil for general use in all temperatures. For winter use (40°F to -10°F), use SAE 10W-30. For summer use (above 32°F), use SAE 30.
This answer is automatically generated
how TO REPLACE THE TRIGGER ASSEMBLY ON ix 2000 GENERAC PORTABLE GENEATOR
How to cancel monthly service fee