D-Notes To The User; E-Enter The Customer Access Code - Traulsen G Series Owner's Manual

VII. d - NOTES TO THE USER:
You only have 20-30 seconds between button pushes. If you take longer than 30 seconds, the controller will revert back
to displaying the cabinet temperature.If you enter the wrong security code, the controller will revert back to displaying the
cabinet temperature. You can exit the parameters at any time by waiting 20-30 seconds for the control to return to normal
operation.
VII. e - ENTER THE CUSTOMER ACCESS CODE:
This is required to set any of the control parameters.
Use the security code "0, A, 1"
SET
Press the set button
SET
Press the set button .
The display will show three zeros with the left zero flashing
SET
Press the set button
The display will show three zeros with the center zero flashing
Press the down arrow key
When you reach "A" press set
The display will show "zero, A, zero" with the right zero flashing
Press the up arrow key
When you reach "1" press set
The display will read
You are now in the CUSTOMER / SERVICE PARAMETERS menu.
VII. MICROPROCESSOR CONTROL (cont'd)
and the following instructions:
. The display will read
.
.
to sequence through F, E, d, C, b, A, 9, 8, 7,...etc.
SET
.
to sequence through 1, 2, 3, 4, 5, 6, 7, 8, 9, A, b,...etc.
SET
.
Thermostat Set Point.
Customer/Service Access.
.
.
.
-8-