Sharp KP-19S Service Manual page 9

1. Remove the bottom cover in accordance with "REMOVE OF BOTTOM COVER".
2. Remove the screw holding earth wire to body.
3. Pull out the body and delivery base cover by toward its bottom.
4. Detach the body from the delivery base cover.
5. Now body is free.
1. Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect the connector lower from the pipe of inner pot.
3. Disconnect the glass pipe from the connect upper.
4. Remove the connector lower from the glass pipe.
5. Now the glass pipe is free.
Note : Re-install glass pipe in accordance with Fig. 9.
The screen must be faced to arrow mark when glass pipe is inserted to connector lower.
Insert by
approx. 10 mm.
1. Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect 3 lead wire of temp. fuse ass'y .
3. Disconnect the 2 terminal of thermostat.
4. Now temp. fuse ass'y is free.
Thermostat lead wire blue
REMOVE OF BODY
REMOVE OF GLASS PIPE
Glass pipe
Screen
REMOVE OF TEMPERATURE FUSE ASS'Y
Temp. fuse ass'y
Thermostat
Terminal
Connector lower
Connector upper
Fig. 9
Fig. 10
9
Glass pipe
Screen
Connector
lower
Temp. fuse lead wire yellow