Sharp KP-19S Service Manual page 10

1.
Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect 2 terminals from the thermostat.
3. Remove 2 screws holding the thermostat.
4. Now the thermostat is free.
1. Remove the body in accordance with "REMOVE OF BODY".
2. Remove the nut at terminal ass'y to release lead wire from the heater set ass'y.
3. Detach the mounting bracket by remove 2 screws holding the mounting bracket.
4. Disconnect the connector lower from the pipe of inner pot.
5. Unfasten 2 screws at heater set ass'y and then pull
heater set ass'y out from inner pot.
6. Now heater set ass'y is free.
REMOVE OF UPPER RING ASSEMBLY AND HANDLE
1. Detach the lid ass'y and remove the body in accordance with "REMOVE OF BODY".
2. Remove the thermostat, mounting bracket and heater set assembly in accordance with "REMOVE OF
THERMOSTAT" and "REMOVE OF HEATER SET ASS'Y".
3. Remove the glass pipe in accordance with "REMOVE OF GLASS PIPE" and remove the ball holder ass'y.
4. Remove the upper ring assembly by pulling it downwards.
5. Remove the handle.
Note 1 : When setting the handle, position it correctly. If reversely set, the handle will come off while using.
Note 2 : For alignment of the inner pot and upper ring, have the corner of hitch part of the upper ring engaged
with welded mark of the inner pot.
REMOVE OF THERMOSTAT
REMOVE OF HEATER SET ASS'Y
Upper ring
Handle
Fig. 13
Inner pot
Heater holder-A
Screw
10
Fig. 11
Inner pot
Heater set ass'y
Approx. 7-8 mm.
Fig. 12
Welded mark
of the upper ring
Upper ring
Ball holder ass'y
Fig. 14
Screw
Thermostat