Chapter 3 - Start-Up Data; Start-Up Data Parameters; Overview - ABB ACH 500 Series Programming Manual

Start-up Data
Parameters

Overview

ACH 500 Programming Manual
This chapter lists and explains the Start-up Data parameters and describes
how to set these parameters. The Start-up Data parameters are a special set of
parameters that allow you to set-up the drive and motor information.
Start-up Data parameters should only need to be set during start-up and
should not need to be changed.
To access the Start-up Data parameters, you must be at Operating Data
Parameter 1 (Output Frequency). Press and Hold the [ * ] key while pressing
the [Right Arrow] key. This will bring you to Start-up Data Parameter A
(Language).
The [Up Arrow] and [Down Arrow] keys are used to change the value or
selection for the Start-up Data parameters. When a parameter is set to the
value or selection you want, press the [ * ] key to enter that value as the
acceptable value and move to the next parameter.
To complete the Start-up Data parameters and return to the Operating Data
parameters, continue to enter the information by pressing [ * ] for each
Start-up Data parameter.
The Range/Unit column in Table 3-1 shows parameter values. The text
following the table explains parameter values in detail.
Chapter 3 – Start-up Data
3-1