Chapter 6 – Parameters
Group 30.4
Information
1 CRI PROG VERSION
2 MC PROG VERSION
3 TEST DATE
Group 30.5
I/O Status
6-40
You cannot alter these parameter values. The Range/Unit column in Table 6-
19 shows parameter values. The text following the table explains parameter
values in detail.
Table 6-19 Group 30.4
Parameter
1 CRI PROG VERSION
2 MC PROG VERSION
3 TEST DATE
This parameter displays the Control Interface Card version installed in your
ACH 500.
This parameter displays the Motor Control Card version installed in your
ACH 500.
This parameter displays the date of the ACH 500 final test.
You cannot alter these parameter values. The Range/Unit column in Table 6-
20 shows parameter values. The text following the table explains parameter
values in detail. The parameters in this group show the status of the I/O.
Table 6-20 Group 30.5
Parameter
1 DI1-6 STATUS
2 AI1 V/mA
3 AI2 V/mA
4 RO1-3 STATUS
5 AO1 mA/%
6 AO2 mA/%
Range/Unit
CRHxxy
Control Interface Card program
version.
MCRxxy/CNTxxy
Motor Control Card program version.
YY.MM.DD
Test date (year,month,day).
Range/Unit
000000
Indication of the status of the six
digital inputs. 0=Open; 1=Closed
0.00/ 0.00
Signal at Analog Input 1 in volts and
milliamps
0.00/ 0.00
Signal at Analog Input 2 in volts and
milliamps
000
Indication of the status of the three
relay outputs. 0=Open; 1=Closed
0.00/ 0%
Signal at Analog Output 1 in
milliamps and percent.
0.00/ 0%
Signal at Analog Output 2 in
milliamps and percent.
ACH 500 Programming Manual
Description
Description