Warning; Package Contents; Initial Setup - PrimaLuna EvoLution Series Manual

Warning
To prevent serious injury, electrical shock or fire:
• Do not operate with the bottom plate removed. Keep away from rain and moisture.
• Disconnect the ac mains cable before changing fuses and/or tubes.
• Do not replace fuses with any fuse other than the same type and rating as used by the factory.
• Do not replace tubes without reading instructions.
• Do not replace fuses or tubes if you have any doubt about your ability to do so.
• We accept no responsibility for any personal or material damage due to incompetent use or users.
Package Contents
EVO Tube Integrated Amplifier
EVO Remote Control
Power Cord
This Owner's Manual
White Gloves
Tube Complement
Spare Mains Littelfuse Model 213 fuse
Spare Adaptive Auto Bias Littelfuse Model 213 fuse
Initial Setup
• Don't wear a watch or rings and carefully remove the EVO Tube Integrated Amplifier from its
packaging. Once the plastic bag has been removed, use the white gloves provided to prevent
fingerprint smudges.
• Remove the tube cage by carefully pulling it up and away from the amplifier.
• Remove the protective foam surrounding the tubes.
• Tubes are already installed.
• Check that each tube is firmly and straightly seated in its socket. Use gloves provided.
• Replace cage back in its place if desired.
• Check to see the power switch is off (down) and the bias-­selector switch is in the correct position.
• Connect each source to the corresponding plugs.
• Connect your speaker wires, positive to positive, negative to negative. This unit is non-­inverting.
• Plug the power cord into the amplifier, then into the wall socket.
• Switch sources on and then switch the amplifier on.
• The tubes will be warmed up and ready to use in about 60 seconds.
EvoLution Series
5
1 piece
1 piece
1 piece
1 piece
1 pair
See specification pages
1 piece
1 piece