Shooting Still Images/Movies - Sony DSC-TX9 Cyber-shot&reg Handbook

Cyber-shot cameras: cyber-shot digital still camera
Hide thumbs Also See for DSC-TX9 Cyber-shot®:
Table of Contents

Advertisement

The remaining charge indicator is incorrect.
• This is caused when you use the camera in an extremely hot or cold location.
• A discrepancy arose between the remaining charge indicator and the actual remaining battery charge.
Fully discharge the battery pack once, then charge it to correct the indication. Depending on
conditions of use, the display may remain incorrect.
• The battery pack is dead (page 179). Replace it with a new one.
Cannot charge the battery pack.
• You cannot charge the battery pack using the AC Adaptor (sold separately). Use the battery charger
to charge the battery.
The CHARGE lamp flashes while charging the battery.
• Check that the battery pack type is NP-BN1.
• The CHARGE lamp flashes infrequently when you use a battery pack that has not been used for a
long time.
• The CHARGE lamp (on the supplied battery charger) has two flash patterns, fast flash (approx. 0.15-
second intervals) and slow flash (approx. 1.5-second intervals). If the lamp flashes quickly, remove
the battery pack being charged, and then insert the same battery pack into the battery charger again
(until it clicks). If the lamp flashes quickly again, this may indicate a battery pack problem.
If the lamp flashes slowly, the charger is in standby mode and charging has temporarily stopped.
Charging stops temporarily and standby mode results when the temperature is outside the range
suitable for charging. Charging resumes and the CHARGE lamp lights when the temperature returns
to the range suitable for charging.
It is recommended to charge the battery pack within the proper charging temperature range between
10°C to 30°C (50°F to 86°F).
• For details, see page 180.

Shooting still images/movies

Cannot record images.
• When images cannot be recorded into a memory card but are recorded into the internal memory, even
though a memory card has been inserted into the camera, make sure that the memory card has been
fully inserted.
• Check the free capacity of the internal memory or the memory card. If it is full, do one of the
following:
– Delete unnecessary images (page 93).
– Change the memory card.
• You cannot record images while charging the flash.
• Switch the
(Still)/
• For recording movies, it is recommended that you use the following memory cards:
– "Memory Stick PRO Duo" (Mark2) media, "Memory Stick PRO-HG Duo" media
– SD memory card, SDHC memory card or SDXC memory card (Class 4 or faster)
• Set [Demo Mode] to [Off] (page 123).
Smile Shutter function does not work.
• No image is shot if a smiling face is not detected.
• Set [Demo Mode] to [Off] (page 123).
(Movie) mode button.
164
GB

Advertisement

Table of Contents
loading

Table of Contents