Using The Gdm-2036S Service Jig; Adjustment Flow Chart; Key Points For Using The Service Jig - Sony Multiscan GDM-2036S Service Manual

GOM-2036S
6-4. USING THE GDM-2036S SERVICE JIG
• Is the cable connected securely?
• Is GDM-2036S's power on?
• Start up the program MS _ SER.
• Follow the instructions as indicated on the screen.
6-4-1. Adjustment Flow Chart
N Board Repair
Is the
Board Adjustment
Finished?
Yes
F-2
Adjust Distortion
in All modes
F-4
Confirm
Adjustment
Is the
Distortion
corrected?
Yes
END
No
No
CRT/DY Replacement 03 Board Repair
F-3
F-7 (Standard Data
Input) Disk Reading
F-1
Adjust the N Board
To Adjust 1 mode
6-4-2.
Key Points for Using the Service Jig
• If
the monitor's power is switched of during use the
computer can get hung up.
• Adjust distortion after entering the user reset mode.
There are two ways to enter this mode:
a. Tum the monitor off and on while pressing two
adjustment buttons.
b. Press the rear adjustment button.
-99-