Safety Instructions - Wideye iFleetONE User Manual

iFleetONE™ Terminal User Manual

SAFETY INSTRUCTIONS

For safety and protection purposes, read the manual before attempting to use the iFleetONE™
User Equipment (UE).
The following general safety precautions must be observed during all phases of operation,
service and repair of this equipment. Failure to comply with these precautions or with specific
warnings elsewhere in this user guide violates safety standards of intended use of the UE.
Addvalue Innovation Pte Ltd assumes no liability for the customer's failure to comply with
these requirements.
Hazard Symbols
Hot Surfaces
Antenna Radiation Warning
and Distance to other
Radiation Equipment
Power Supply
Avoid touching those areas of the UE that are marked
with this symbol otherwise it may result in injury.
For safety reasons, all personnel must keep at least
1 meter from the antenna.
Turn off the power at the mains switchboard before
beginning of the installation.
Confirm the power voltage is compatible with voltage
rating of the equipment. It is highly recommended to use
12V - 24V DC, 12.5A - 6.25A power line, provided that it
is available on the vessel.
If there is no suitable DC power line provided by the
vessel, an external AC/DC power supply (input range of
100~240V AC, 50~60Hz) with an output of +24V DC,
6.25A can be used.
Note: The requirements of the AC/DC power supply
should take care of high surge current of 25A at 24V
DC for 1ms.
Page 8 of 100