Computherm KonvekPRO Operating Instructions Manual page 8

It is expedient to find a place where
is exposed to radiant heat (from the gas
heater) to the smallest extent possible. With
the help of the actual size template shown on
the previous page mark the hole locations for
fixation.
2.4. Prepare the holes (Ø6 mm), put the dowels
and screws into them so that 3-4 mm of the
screws protrudes from the wall.
2.5. Insert the probe of the gas heater carefully
into the KonvekPRO. The probe receiving
socket of the
to receive a Ø6-12 mm probe. When insert-
ing the probe, make sure that the probe is
always inserted perpen-
dicularly
oriented to its right lower
side viewed from the front
so that it fits in the hole on
the other (upper) side.
KonvekPRO
KonvekPRO,
to
- 8 -
KonvekPRO
is universal and able