Computherm KonvekPRO Operating Instructions Manual page 5

KonvekPRO
is connected to with 2 wires therefore it
should be located at a distance that allows you to
connect it and its location is accessible for adjust-
KonvekPRO
ment. If you want to control with a wire-
less thermostat then it is recommended that you
locate the receiving unit of the thermostat in the
vicinity of KonvekPRO. In this case the thermostat
can be moved anywhere within the range.
IMPORTANT WARNING! For proper operation of
the gas heater controller turn the temperature
regulating knob in the gas heater to approx.
30 °C (in case of FÉG products it is grade 6-6.5
on a scale to 7).
2. PUTTING THE GAS HEATER
CONTROLLER INTO SERVICE
Warning! The appliances must be put into
operation by a competent person!
WARNING! Any modification of the appliance
poses a risk of electric shock or failure.
- 5 -