Computherm KonvekPRO Operating Instructions Manual page 6

2.1. Get the things included in the package of
COMPUTHERM KonvekPRO
KonvekPRO, PSU, 2 dowels and 2 screws. You
will also need a pencil, a drilling machine,
small (flathead and Phillips) watchmaker's
screwdrivers, a Ø6 mm drill bit and, maybe,
a hammer.
2.2. Carefully lift out the probe on the back side of
your gas heater from its socket. The probe is
normally located on the back side of the gas
heater, in rare cases it is beneath the cover
at the end of an approx. 50 cm long copper
pipe.
2.3. Find some place suitable for fixing KonvekPRO
in the vicinity of the gas heater (wall, window
frame), considering the length of the copper
pipe that connects the gas heater and the
probe.
ready: appliance
- 6 -